4 Zone Battery Wall control for 24 volt Single colour Pixel LED strip

4 Zone Wireless 2.4G RF Wall control for 24 volt single colour Pixel LED strip. This device is to be used in conjunction with 4 zone wireless receivers PIXRF-BT or PIXWF-BT .Operating distance up to 20 metres. The remote includes zones 1-4. Music mode - Allows the receiver to pick up sound as its got a built in microphone Speed button - speed the modes up or slow them down. Mode + and - button to allow you to go through the modes. Wheel slider allows Dimming. To sync the LED strips onto different zones on the wall controller you must do the following. For example tape 1 - Turn on - within 10 seconds press and hold the zone button you want the tape to sync to. The tape will flash 2-3 times. Then turn that tape off. Go to your next tape. Tape 2- turn on. Repeat above but onto the next zone. Once that's completed you can turn back on your other zones and they will all be separate from one another. Then use the All button on the remote to operate altogether. Multiple receivers can be controlled by one remote together or separately across 4 zones . 12 month warranty on remote controls To link a receiver to a zone on the wall controller . Switch power to receiver off . Then within 2 seconds of switching back on ,press a zone button at the bottom .If linked the led strip connected to the receiver will flash 2 or 3 times . Repeat the process to link other receivers to other zones but disconnect power to receivers already linked to other zones first.